Shopping Cart

Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connectos to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included).

Not for PowerJolt SE. The holder Fits only the old Griffin PowerJolt cable with release buttons on the side.

Compare the connector in the picture with the connector on your cable in order to find the correct holder.

The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

Please read all instructions and look at the pictures before attaching the holder.

1. Installation of cable: Place the holder with the backside upwards. Place the connector into the lower part of the holder. Place the back piece over the connector, make sure the cable is in the correct position. Screw the back piece into place using the removed screws. The cable is in place.

2. Installation of holder: Loosen the screw in the center of the holder so you can remove the attaching part on the back.

3. Place the attaching part on desired position. Screw the attaching part into place with the enclosed screws. Place the holder over the attaching part. Screw the holder onto the attaching part.

4. The holder in place, with cable in place.