Shopping Cart

Use an active holder for your MP3-player while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation -safe and convenient! The holder is equipped with a cig-plug for connection to the vehicle's 12 Volt socket. If you have a car with USB interface you can disconnect the cig-plug from the holder’s cable in order to get a USB-cable which you can connect directly to the USB connector in your vehicle.

The holder is adjustable in width and depth. Fits devices with or without skins.

The device automatically connects to the charging device every time you put it in the holder. The active holder is equipped with an Apple-approved cable from Griffin (PowerJolt). The active holder is attached to a tilt swivel, this means you can adjust the angle of the device in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.

Please read all instructions and look at the pictures before attaching the holder.

1. Installation of cable: Place the holder with the frontside upwards. Place the connector into the lower part of the holder. The mark pointing upwards, so you can see it when placing the connector into the holder. Place the lid over the connector, make sure the cable is in the correct position. Press the parts together and flip the holder so the backside is upwards. Screw the lid into place by using the enclosed screws. The cable is in place.

2. Adjustment of holder: Loosen the screws in the back of the holder. Pull the sides of the holders apart. Place the device in the holder. Press the sides of the holder together so the device is in a firm position but can be slided into and out of the holder. Tighten the screws in the back of the holder.

3. Installation of holder: Loosen the screw in the center of the holder so you can remove the attaching part on the back. Place the attaching part on desired position. Screw the attaching part into place with the enclosed screws. Place the holder over the attaching part. Screw the holder onto the attaching part.

4. The holder is in place.