Shopping Cart

Fits for all cables! A holder that provides a neat, firm installation for many areas of use. All cables that can be used with the iPad can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the iPad each time you put it in the holder. (Cable not included)

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car. Attach onto a ProClip Mounting Platform.

Please read all of the instructions and look at the pictures before attaching the holder.

1. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. All cables that fit the device, can also be connected to the holder.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.