Shopping Cart

Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connectos to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)

The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

Please read all of the instructions and look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply.

1. Installation of cable: Place the holder with the frontside upwards. Place the connector into the holder. The mark pointing upwards, so you can see it when placing the connector into the holder. Place the lid over the connector, make sure the cable is in the correct position. Screw the lid into place by using the enclosed screws.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place in upright, horizontal position.