Shopping Cart

Use an active holder for your iPad 2 while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation -safe and convenient! The holder is equipped with a cig-plug for connection to the vehicle's 12 Volt socket. If you have a vehicle with USB interface, you can disconnect the cig-plug from the holder’s cable in order to get a USB-cable which you can connect directly to the USB interface in your vehicle.

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad 2 into place in the holder, and to take it with you when leaving the car. Attach onto a ProClip Mounting Platform.

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder Carefully, slide the device sideways into the holder so you hear/feel it snaps into place.

3. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place in upright, horizontal position.