Shopping Cart

The choice for you who use a Parrot MK9000 series with your iPhone 4. You easily attach the Parrot-cable to the holder. Your iPhone will then be automatically connected to the Parrot-cable each time you put the device in the holder, you do not need to attach it manually.

The holder is padded and equipped with a tilt swivel so you can adjust the angle of your iPhone. (Cable not included.) Attach onto ProClip Mounting Platform. Neat, convenient and safe!

Please read all instructions and look at the pictures before attaching the holder.

1. Installation of cable: Remove the screws on the back of the holder so you can remove the back piece. Place the holder with the frontside downwards. Place the connector into the lower part of the holder (the mark poitning downward so you can not see it).

2. Place the back piece over the connector, make sure the cable is in the correct position. Screw the back piece into place using the removed screws. The cable is in place.

3. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.