Shopping Cart

Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connects to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)

Only for the new Griffin PowerJolt cable without release buttons on the side.

Compare the connector in the picture with the connector on your cable in order to find the correct holder. The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

Please read all instructions and look at the pictures before attaching the holder.

1. Installation of cable: Place the holder with the frontside upwards. Place the connector into the lower part of the holder. The mark pointing upwards, so you can see it when placing the connector into the holder. Place the lid over the connector, make sure the cable is in the correct position.

2. Press the parts together and flip the holder so the backside is upwards. Screw the lid into place by using the enclosed screws. The cable is in place.
Adjustment of holder: Loosen the screws in the back of the holder. Pull the sides of the holders apart.

3. Place the device in the holder. Press the sides of the holder together so the device is in a firm position but can be slided into and out of the holder. Tighten the screws in the back of the holder.

4. Installation of holder: Loosen the screw in the center of the holder so you can remove the attaching part on the back. Place the attaching part on desired position. Screw the attaching part into place with the enclosed screws. Place the holder over the attaching part. Screw the holder onto the attaching part. The holder is in place.