Shopping Cart

Holder with cable plug attachment. The cable is easy to attach to the holder, and then the cable connects to the phone automatically when you put your unit in the holder so you do not have to connect it manually each time. (Cable not included).

The holder Fits only the New Griffin PowerJolt cable with release buttons on the side.

Compare the connector in the picture with the connector on your cable in order to find the correct holder. The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

Please read all of the instructions and look at the pictures before attaching the holder.

1. Installation of cable: Place the holder with the front side upwards. Place the connector into the lower part of the holder. Place the back piece over the connector, make sure the cable is in the correct position. Screw the back piece into place using the removed screws. The cable is in place. Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted.

2. To adjust the holder for your device: Place the device in the holder and press the sides together so the device is firmly in place. Tighten the screws on the back side of the holder.

3. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.