Shopping Cart

Now in Your Cart (0) Items


Device Holders

Car Proclip Mounts



http://www.simplymounts.com/brodit-model-Apple-iPhone-5-3549/
http://www.simplymounts.com/brodit-model-Samsung-Galaxy-S4-GT-I9505-3654/
http://www.simplymounts.com/brodit-model-Apple-iPhone-4S-3308/
http://www.simplymounts.com/brodit-model-Apple-iPad-New-with-Retina-(Lightning-Connector)-3568/
Home > Brodit > Eten Glofiish X800 Brodit Active Holder Tilt Swivel (#971759)
Bookmark and Share

Eten Glofiish X800 Brodit Active Holder Tilt Swivel (#971759)

Product ID: Brodit 971759

Product Type: Brodit Active Holder Tilt Swivel

Product Model: Eten Glofiish X800 for Alla

Inc VAT : £ 59.99
Ex VAT : £ 49.99
Stock: In Stock [Qty 1]

Today’s Price £ 59.99 Inc VAT
  • Add to Wishlist
  • Also Compatible with Products

Product Details

For fixed installation with Molex adapter system. 2A charger.

Technical Detail

The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior.

With the Molex adapter system you can get power for a Bluetooth GPS receiver etc. (The device does not support datatransfer.)

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto a ProClip Mounting Platform.

Instalation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters.

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. 4. The holder is in place.

Product Instalation Images


Shop By Make
  • Acer
  • Acura
  • Airo
  • Albecom
  • Alcatel
  • Alfa Romeo
  • Alpine
  • Amazon
  • Amitech
  • Apple
  • Asus
  • AT&T
  • Audi
  • Audiovox
http://www.simplymounts.com/p/delivery-details-simplymounts/